remove noise from measured data
조회 수: 2 (최근 30일)
이전 댓글 표시
Hi All,
I am reading this page from Matlab, and I have the following question from it. Can you please explain? It says: "The filter is designed to allow all frequency components with a period less than 48 hours and block all components higher than that." So my question is: based on what it says, how did it come up with the following values?
% Filter Order
N = 3;
% Passband frequency
Fpass = 1/(24*60*60);
% Stopband frequency
Fstop = 1/(6*60*60);
% Ripple Factor and Attenuation in stop band
Rp = 0.5;
Astop = 50;
Thanks
댓글 수: 3
John BG
2017년 6월 29일
1/(24*60*60) is the slowest fastest signal that the filter is going to let in, or should let in, without significant attenuation. 1/(6*60*60) is a 6 hours cycle signal that the filter will block. 6 hours cycle is the frequency (f=1/T) where the 1st notch of the filter is going to be placed to attenuate faster signals.
The question reads 'let through frequencies lower than 1/2days' the 48 hours, but the pass / stop frequencies chosen are not that stringent.
답변 (0개)
커뮤니티
더 많은 답변 보기: ThingSpeak 커뮤니티
참고 항목
카테고리
Help Center 및 File Exchange에서 Single-Rate Filters에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!