Change simulink port location of signal after dragging block into "Create Subsystem"
조회 수: 3 (최근 30일)
이전 댓글 표시
Often times when I create a subsystem from a group of Simulink blocks, the inport and outports have the signals entering into the top.
I cannot find a menu entry to change these ports so the signal enters from the side, like normal. The only solution I have found is deleting the block and putting in a new inport/outport.
Is there a way to change this characteristic? It isn't a lot of work but it can add up (deleting the port tends to change all my port numbering and I have to reconnect signals outside the subsystem.
댓글 수: 0
채택된 답변
Sebastian Castro
2017년 6월 19일
It's the same block; you just have to rotate it and resize it to make it look like a "fresh" block.
You can right-click the block and use the context menu to rotate and resize blocks.
- Sebastian
댓글 수: 2
Sebastian Castro
2017년 6월 20일
Yeah, it is, but as you said it won't mess up your numbering.
What I usually do is use the shortcuts for rotating (Ctrl+R or Ctrl+Shift+R) and then select all the "messed up" ports, select a "good" one, and use the "match sizes" option, or whatever it's called. Makes things look better.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Subsystems에 대해 자세히 알아보기
제품
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!