Plotting two 3D figures (mesh,surf) - set different parameters
조회 수: 10 (최근 30일)
이전 댓글 표시
Hello everybody,
I'm trying to display two 3D figures into the one plot. What I'd like to do is to set the different parameters for them in order to make the figure clear and readable (since they are overlapping each other). Concretely, the desired goal could be surface with a certain colormap vs single color mesh with lower transparency.
Maybe I'm going to use fill3 instead of mesh but even then I'd like change its properties (transparency, color).
Thank you people. King regards, Vasek
댓글 수: 0
채택된 답변
Jacob Halbrooks
2012년 3월 22일
편집: John Kelly
2015년 2월 26일
There are lots of properties for a surface object that allow you to control transparency.
You can also use ALPHA to quickly apply transparency:
h = surf(peaks);
alpha(h, 0.5)
There are also lots of properties and helper functions for coloring. See Coloring Mesh and Surface Plots.
댓글 수: 3
Jacob Halbrooks
2012년 3월 22일
The ALPHA function lets you specify a particular surface to apply to:
>> s1 = surf(peaks);
>> hold on;
>> s2 = surf(peaks+5);
>> alpha(s2, 0.1);
However, COLORMAP does not provide this fine of control and applies the map to either the entire figure or axes. To use multiple colormaps in a single figure, there is a technical support guide:
http://www.mathworks.com/support/tech-notes/1200/1215.html
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Surface and Mesh Plots에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!