A command such as "figure('Position',[800 650 560 420])" also displays the figure in top left corner before going to specified position. It seems that some internal setup procedure is prematurely displaying the figure.
Odd initial figure behavior in R2016b
조회 수: 2 (최근 30일)
이전 댓글 표시
Just installed matlab R2016b(64bit) on Fedora 25 and found that the figure command exhibits a strange behavior: the figure shows up in the top left corner of my screen momentarily and then jumps to the position set by 'DefaultFigurePosition'. Quite annoying. How do I get the figure to display in the right place initially?
채택된 답변
Sindhu Priya
2017년 3월 7일
편집: Sindhu Priya
2017년 3월 7일
As MathWorks officially did not support all flavors of linux (check this link for supported platforms)
All functions may or may not work as expected.
Possible work around for the issue is,
copy the following command to startup.m file in MATLAB’s Startup Folder (or create a new 'startup.m' if one does not already exist)
>> set(0,'defaultfigureposition',[800 650 560 420]);
Regards,
Sindhu
댓글 수: 0
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Startup and Shutdown에 대해 자세히 알아보기
제품
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!