Fault location using transient wave analysis

조회 수: 9 (최근 30일)
Muruganandham Subramanian
Muruganandham Subramanian 2012년 3월 12일
Hi, Am doing fault location in transmission system (Single end method) using transient wave analysis method. Here, First i converted the three phase voltages(Va, Vb & Vc) into modal voltages using clarke transformation. Then i have to use DWT to find the coefficients of faut timing(i.e. fault duration).How to find this?

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

harish bharadwaj
harish bharadwaj 2012년 3월 13일
Hi,
may be u can find this by using DWT block available in simulink.

카테고리

Help Center 및 File Exchange에서 Wavelet Toolbox에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by