Can BrickPi be programmed from Matlab/Simulink to control LEGO NXT sensors and motors?
조회 수: 1 (최근 30일)
이전 댓글 표시
Hi, Has anyone tried controlling LEGO NXT sensors and motors via BrickPi over Raspberry Pi 3's on-board WiFi? BrickPi is essentially an expansion board to Raspberry Pi: https://www.dexterindustries.com/BrickPi/.
BrickPi officially does not support Matlab/Simulink yet. I am wondering if anyone can point me to relevant resources to help figure out how to access and control these motors and sensors. Thanks, Gautam
댓글 수: 1
René van der Meer
2017년 12월 24일
Gautum, this is a very good idea! I would love to use this as well. I hope that someone already has done this. Otherwise would could start with the Dexter SW?
채택된 답변
Jannik Hahn
2019년 12월 9일
Hi Gautam,
maybe a bit late, but you can use the "Simulink Support Package for Raspberry Pi Hardware" and control the motors and sensors via SPI. I actually use the "SPI Master Transfer" and extract the needed inputs from the c++ libraries provided by Dexters BrickPi3-master.
Cheers Jannik
댓글 수: 6
추가 답변 (0개)
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 LEGO MINDSTORMS EV3 Hardware에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!