simscape and simpower sysystem
조회 수: 3 (최근 30일)
이전 댓글 표시
I want to connect inverter output to variable resistor.Two blocks are in simpowersystem and simscape respectivy. how to connect? please help me...
댓글 수: 0
채택된 답변
cr
2012년 3월 4일
It isn't clear from the question what exactly you mean, but in case you want to use blocks from these two domains in the same model, please note that Simpowersystems (SPS) and SimScape(SS) are different domains and blocks from these domains cannot be connected with those in other domains directly. Information exchange can be done by using converter blocks (ps-s and s-ps). E.g. you want to change resistance based on a voltage signal in SPS. Feed this signal to variable resistor via s-ps block of SS.
댓글 수: 0
추가 답변 (2개)
zia kansi
2014년 9월 3일
hey every body...i have also the same problem i am unable to connect my inverter voltage output to the motor block(made by me not built in block). the S-ps and PS-s converter do not work. so any body please is there any other solution?? please help me.. if there is some other alternative so please tell me...thanks
댓글 수: 0
rez
2015년 11월 7일
how do i use on mathlab/simulink a point on voltage wave for varing the firing angle with added resistance to reduce transformer inrush current at the energisation? thank you
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Foundation and Custom Domains에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!