- 'Frequency' and 'sample time' of each of the three "sine wave" blocks you are using.
- The length of FFT .
How to analyse spectrum for frequency and magnitude in simulink
조회 수: 2 (최근 30일)
이전 댓글 표시
Hi,
my goal is to analyse an ofdm-signal at the receiver site. I think therefor i have to sweep the FFT output for frequency and magnitude detection. With the magnitude i will conclude on the transmitted data for each subcarrier / frequency.
Now i worked out an easy ofdm-transmitter with three added frequencies, which should be modulated with a bitstream later.
But that output signal wasn't that i expected.
The same in detail:
So what did i wrong with the fft-signal or how can i use the complex signal for my application?
How is the complex signal made of and how can i sweep all frequencies for their magnitude?
Best regards!
댓글 수: 1
Jyotish Robin
2016년 8월 1일
It is not clear from your model what are some of the inputs of the "add" block you used. Kindly specify them. It will be useful if you could provide the following additional details:
답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 OFDM에 대해 자세히 알아보기
제품
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!