필터 지우기
필터 지우기

How to use more than 1 powergui in the same model?

조회 수: 2 (최근 30일)
Katy Zita
Katy Zita 2016년 3월 17일
답변: Sabin 2024년 1월 22일
Hello everyone, I am building a microgrid that I will be using for testing my multiagent system, which means that I know just a little in Matlab... In this microgrid, I need to have a PV, which works in discrete mode, and a wind turbine, which works in phasors mode, and an emergency DG, which works in continuous mode. Since they work in different powerguis, I cannot have them all in the same model. I thought at first to separate the models and use model reference (model block variant) to call them, but still this solution doesn't work. I am having really a hard time and I cannot figure out how to solve this issue. I need your assistance all please with a solution easy to understand and can get me off this problem. Thanks a lot all of you

답변 (1개)

Sabin
Sabin 2024년 1월 22일
You can use multiple powergui blocks in a system that contains two or more independent electrical circuits that you want to simulate with different powergui solvers.
To do so, put each circuit in a different subsystem, and then add a powergui block inside each subsystem.
When you use more than one powergui block in a model:
  • Do not place a powergui block in the top-level diagram.
  • Place every independent model in a different subsystem.
  • Place a single powergui block in the top level diagram of every subsystem.

카테고리

Help CenterFile Exchange에서 Electromechanical에 대해 자세히 알아보기

제품

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by