Problem: figure height apparently limited to screen height
조회 수: 1 (최근 30일)
이전 댓글 표시
My objective is to save a "tall" figure with a height that exceeds my display height. I used:
>> figure('units', 'normalized', 'outerposition', [0 0 2 2]);
in an attempt to make a figure "taller" (with a greater height) than that of my single monitor. However, the figure resized when displayed to only occupy the screen height (so that the normalized outer position height was effectively "1").
I do use export_fig, and I am unclear if it has an internal solution; the help menu did not specify.
Solutions? Thanks in advance.
댓글 수: 0
답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Line Plots에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!