xPC target using UEI PD2-MF-64-3M/12H

조회 수: 1 (최근 30일)
Nir
Nir 2011년 12월 26일
I'm relatively new to xPC. I have UEI PD2-MF-64-3M/12H as data aquisition board in my target PC, and I've built a simple model to grab the data and send it to the host (I'm using Matlab 2010a).
The model is running fine, but all the data is 0. Even when I connect a fixed input voltage, I don't see any data.
It looks like the board is simple not enabled.
I'd appreciate some help on whaty can I do to find out what I'm doing wrong.

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Gordon Weast
Gordon Weast 2012년 2월 10일
Contact Tech support and provide a sample model that shows the problem. It could be just a setup problem, but it's hard to tell without seeing the model and all the settings.

카테고리

Help Center 및 File Exchange에서 Multicore Processor Targets에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by