Using PMSM model for electric vehicle simulation

I'm using a PMSM model (the one in the AC6 example) for an electric vehicle and i want to simulate the motor ME1115. But there is no place in the model to change the power. So how exactly can i change that?

Answer 1

[ahmad yasser]

Did you find how to set the power rating of the motor?

[Alexandre Bitencourt]

You control the electrical power by inductances Ld and Lq, sadly my motor's datasheet didn't have this information, so i had to keep changing those values until find a good result. Keep in mind that Lq should be a little bit greater then Ld (look at the motor equation) and the controller must have the same Ld and Lq values, if he uses it.