Example c2000 concerto on the leds

Hi,

I tried this example of the LEDs on Matlab.

I have a problem in managing the LEDs . From datasheet card there is no correspondence with the LEDs indicated by example. Infact there is led 1 with GPIO 70 but not LED 2 .

Also, if I try to use the C28x processor to turn on the LED 3 ( GPIO71 ) nothing happens .

Who can help me ?

Thank you

Luigi

[Andres]

I have the same issue. I tested the board using CCS Studio and LED2 correspond to GPIO 70. So I think the model is ok.

Also If I follow the M3 example everything works . The issue comes when you try to load the C28x model into the processor. Is not loading at all. These are the last two lines I got form the diagnostic viewer. ### Successful completion of code generation for model: led_blink_f28m35_c28 Build process completed successfully ------ I think it should attempt to load and Run but nothing happens.

Answer 1

[Andres]

This Worked for me :

Reinstall the support packages for C2000 Concerto

Install the latest version of ccs studio.

Change in configuration parameters in the code generation pane, the Toolchain settings , Toolchain = Texas Instruments Code Composer Studio V6 (C2000)

I hope this can help.