How can i design a variable inductor for three phase inverter in simulink?

I am trying to build variable inductor model in three phase voltage source rectifier and i have used the program for the variable inductor design i.e., "power_VariableInductor" (You can run this program in Matlab) but when i use the same design in my three phase voltage source rectifier then there comes problem in the block i.e., "Inject inductor current" and receive the message when i run the simulation i.e.

"The 'Variable Inductance1/Inject Inductor current ' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model."

There is also same design used in the following paper

http://ieeexplore.ieee.org/stamp/stamp.jsp?tp=&arnumber=4581201

Please guide me about the mistake i am making in the design of variable inductor

Answer 1

[Adam Barber]

Hi Muhammad,

As the error indicates, you likely have left the "Inject Inductor Current" block open-circuit. In the "power_VariableInductor" example, this block is in the "Variable Inductance" subsystem and is closed-circuit. First, I would make sure that yours is implemented in a similar manner. If it is, please upload the model so that we can take a look.

Unfortunately, I cannot look at the paper you linked because I do not have a subscription. You may want to try and describe what they are doing a bit if the above does not help.

Best of luck,

-Adam

[Muhammad]

Hi Adam

Thanks for your suggestion, i solved my problem already. Thanks.

Regards Muhammad Saleem

Answer 2

[siwei yang]

Hi，I am researching this topic and having the same question，can you share your solution about this problem，thank you very much。

I will very appreciate if you can send me an email to [e-mail]

Thanks again!

Answer 3

[Elon Yao]

Hi I got the same error message, the reason is that I connected nothing with this subsystem and click the run button