How to limit the motion of a prismatic joint
조회 수: 34 (최근 30일)
이전 댓글 표시
When I am modelling a prismatic joint and I start the simulation the joint just drops under gravity and falls off. How do I limit the range of its motion
댓글 수: 0
채택된 답변
Sebastian Castro
2015년 7월 29일
To do this, you can create a contact force that is applied to the joint based on some limits.
For a simple limit like this you can use the SimMechanics-Simscape interface blocks on the joint and connect it to a Translational Hard Stop block from the Simscape library.
For more complicated contact relationships, you may want to look at the SimMechanics Contact Library on the File Exchange.
- Sebastian
댓글 수: 10
Sebastian Castro
2015년 8월 3일
You could make a controller that measures the position of the object and moves it either up or down along the belt by applying a force.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Multibody Dynamics에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!