Problem with RLC block
이전 댓글 표시
I am using the blue component RLC, setting R = 100kOhms and L = 0.0011/377 ;
My issue is this, When I set SERIES RL then I get a very high current in the circuit, but when I select onle R then the current is low as expected. It doesn't make sense having high current when putting a series L which impedance is Low compare to R, both option should have the same current values. what's wrong?
this is my solver:

My circuit is a simple source -transformer-load, the transformer is just 1:1 source s 300kV.
This is the current wjhen RLC load is "SERIES RL"


Here is the sme circuit but with RLC Load just a resistor R, not change in value. this looks more reasonable.

댓글 수: 1
Vedant
2026년 10월 30일 10:52
yes, the current should be the same since the inductance impedence is very small compared to 100kohm. I dont think this is to do with the solver honestly, might be worth checking the series RL config and units again
답변 (0개)
카테고리
도움말 센터 및 File Exchange에서 Switches and Breakers에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!