How to generate a .iq file from i q data in matlab?

조회 수: 88 (최근 30일)
Eric
Eric 2024년 11월 4일 19:37
댓글: Walter Roberson 2024년 11월 5일 5:14
How do i generate a .iq file from the i q data from a matlab script exactly? Any help will be appreciated.
  댓글 수: 3
Eric
Eric 2024년 11월 4일 21:31
편집: Eric 2024년 11월 4일 21:45
Do you have example matlab code?
Walter Roberson
Walter Roberson 2024년 11월 4일 21:58
No, and I do not see any code posted anywhere for that purpose.
I find MATLAB code for a different .iq file format at https://pysdr.org/content/iq_files.html

댓글을 달려면 로그인하십시오.

답변 (1개)

Jaimin
Jaimin 2024년 11월 5일 4:27
To generate a “.iq” file in binary format from IQ data in MATLAB, you need to follow these steps:
  1. Prepare Your IQ Data
  2. Open a File for Writing
  3. Write the Data
  4. Close the File
To open a file, write data to it, and then close it, you can utilise the fopen, fwrite, and fclose functions respectively.
Kindly refer to the following MATLAB script for understanding. (This script assumes you want to write the IQ data in a simple interleaved binary format.)
% Example IQ data
I = [0.1, 0.2, 0.3, 0.4]; % In-phase component
Q = [0.5, 0.6, 0.7, 0.8]; % Quadrature component
% Combine into complex format
IQ_data = I + 1i*Q;
% Open a file for binary writing
fileID = fopen('output.iq', 'wb');
% Check if the file opened successfully
if fileID == -1
error('Failed to open the file.');
end
% Write the IQ data to the file
% Here, we assume single precision (32-bit) for both I and Q components
fwrite(fileID, [real(IQ_data); imag(IQ_data)], 'float32');
% Close the file
fclose(fileID);
disp('IQ data has been written to output.iq');
The script uses float32 to represent each I and Q component. Adjust the data type as needed (e.g., float64 for double precision).
For more information about “fopen”,fwrite” and “fclose” kindly refer following MathWorks Documentation.
I hope this will be helpful.
  댓글 수: 1
Walter Roberson
Walter Roberson 2024년 11월 5일 5:14
@Eric earlier asked a similar question but phrased it as being related to aaronia rtsa suite. That makes it more likely that the file format being referred to is the one described in the link I posted above. But it is certainly not clear which file format Eric requires.

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Low-Level File I/O에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by