Bidirectional converter for an energy storage system
조회 수: 11 (최근 30일)
이전 댓글 표시
I have tried to design a bidirectional convert, but I can't find to figure out why the battery will not discharge to the main grid.
Here is an overview of the design:
I want the SOC of the battery to control the direction of the thryistor. With the use of relay I want the battery to discharge at 80% and charge when it's below 40%. This goes into the Pulse Generator which will send the signals to the bridge.
Is there any obvious faults in my design? Also, is it possible to use the "Simpowersystems simscape interface" as the design shows?
Outside of the subsystem I have to generators that produces 666kVA, and a motor with a rated 837kVA.
댓글 수: 1
SALAH alatai
2022년 7월 17일
@Roy Azlan Jensen have you got it?
looking to same control of SOC , could you pls share with me. thanks
답변 (1개)
Joel Van Sickel
2022년 7월 18일
Hello,
unfortunately, there is not enough information from the screen shot to know for sure what is wrong. If possible, share a model in these situations. It does look like the feedback control may be too simplistic. Also, it looks like you are combining simscape components with specialized power systems. Both utilize different solver technologies, so it would be best to use one or the other. As they have many similar components it is usually unecessary to combine the two.
Here is an example of actively controlling a thyristor rectifier. Please use it as a starting point.
Regards,
Joel
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Energy Storage에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!