How could I go about creating a variable load for a CubeSat at different modes of operation, using conditional logic?
조회 수: 1 (최근 30일)
이전 댓글 표시
I am trying to simulate the power subsystem of my team's cubesat, and I have started a simple simulation. The goal is to measure the power useage of the cubesat over an orbital period. The cubesat has three modes of operation that are relevant here: talking, idle, and imaging mode. I am modelling the loads of each of the subsystems using resistors, solving for their values from the total voltages and the power consumption.
I am stumped on how to approach varying the loads in different modes, I was thinking of using a multi-port switch but I do not think this is what I am looking for. I am looking for some way to use conditional logic (if time within the orbital period is x, turn this branch on, if its x>a, turn this other branch on).
답변 (1개)
Dallas Perkins
2024년 4월 19일
Hi Chris,
Stateflow is a great tool to model modes and conditional logic. You could use a Stateflow chart to control values feeding into variable resistors based on mode, or switch on/off different fixed-value resistors. If you know the load wattage you could also use the dynamic load block.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Electrical Sensors에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!