- https://www.mathworks.com/matlabcentral/answers/756869-how-to-solve-this-error-error-nonlinear-iteration-is-not-converging-with-step-size-reduced-to-hmin#comment_1845719
- https://www.mathworks.com/matlabcentral/answers/1837283-caused-by-nonlinear-iteration-is-not-converging-with-step-size-reduced-to-hmin-1-07322e-15-at-tim#answer_1099018
How to solve the simulation error ,try reducing the minimum step size and/or relax the relative error tolerance.
조회 수: 12 (최근 30일)
이전 댓글 표시
HI,
I am working on a hexacopter model and i am getting the following error
An error occurred while running the simulation and the simulation was terminated
Caused by:
- Solver encountered an error while simulating model 'FullHexacopterwithoutpositionandwithwindmodel12thapril' at time 5.0198902479053622 and cannot continue. Please check the model for errors.
- Nonlinear iteration is not converging with step size reduced to hmin (1.78342e-14) at time 5.01989. Try reducing the minimum step size and/or relax the relative error tolerance.
Component:Simulink | Category:Block diagram error
댓글 수: 0
답변 (1개)
Suman
2024년 6월 19일
Hi Agnes,
Please refer to these answers where the users have faced similar issue:
댓글 수: 1
Agnes
2024년 6월 21일
Hi Suman
Thank you for your response. I will look into the links that you have provided above.
참고 항목
카테고리
Help Center 및 File Exchange에서 General Applications에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!