필터 지우기
필터 지우기

How to model a RC LPF in simulink

조회 수: 9 (최근 30일)
Daniel Nedlich
Daniel Nedlich 2024년 2월 23일
답변: Daniel Nedlich 2024년 2월 25일
I am trying to model a RC LPF (lowpass filter) in simulink, but I don't want to use the inbuilt block that already exists. I have found the transfer function and made a simulink model of it. In this case I use R3=4700 ohm and C3=47nF which gives a cutoff frequency of about 720 Hz. But when I send in two sine waves, one with an amplitude of 1 and a frequency of 1000 Hz, and one with an amplitude 15 and a frequency of 100 Hz. The results show no difference. The signal is the same before and after. The sample time is set to 100e-6. What have I done wrong? Thanks for any help.

채택된 답변

Daniel Nedlich
Daniel Nedlich 2024년 2월 25일
Solved! Decrease cutoff frequency.

추가 답변 (0개)

카테고리

Help CenterFile Exchange에서 Signal Generation에 대해 자세히 알아보기

제품


릴리스

R2023b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by