- If the Dashboard Scope block is inside a referenced model, the plot does not update during simulation.
- No support for rapid accelerator simulations.
- Signals that are reduced through optimizations such as block reduction or accelerator mode aren't displayed in the plot. To view such a signal, mark the signal for logging.
How to eliminate delays in drawing a graph during modeling in Simulink, in a dashboard?
조회 수: 3 (최근 30일)
I work in Simulink.
I am making a model with cyclic calculations. The model is complex, I’m struggling with speed, trying to optimize the calculations.
To visualize the results of the cycles during the calculations, I would like to use a graph. I took it from the dashboard...
But the results are not displayed on the graph in simulated time. There are long delays in displaying monitored parameters on the graph.
Sometimes the display is formed only after all modeling cycles have been completed.
Is it possible to eliminate the delay in drawing graphs in Simulink, in a dashboard?
Sara Nadeau 2023년 10월 7일
Have you looked into any of the limitations listed in the documentation for the Dashboard Scope block?
Notable limitations include:
Does the plot update after the simulation ends?