how to make bode plot in simulink system
조회 수: 31 (최근 30일)
이전 댓글 표시
Hello,
I have one question about how to make a bode-plot in simulink system.
I made one simulink system using PMSM.
and I want to check system margin using bode-plot.
I tried example simulink system from help desk.
but it was different .
Aslo I know that if there are transfer function, it's possible to make bodeplot easily.
but I don't know the transfer function.
So I ask you.
please let me know.
best regards,
Kim
댓글 수: 0
채택된 답변
Sam Chak
2023년 9월 7일
Hi @Kyungmin
You can insert the Bode Plot block in the Simulink model and follow the steps described in this link for visualizing the Bode response of the Model during simulation as shown in the following example. However, your PMSM is a little complicated to me. Generally, you need to mark the signals (right-click the signal and select Linear Analysis Points) to identify the open-loop Input and the open-loop Output. And then on the Linearization Tab (double-click the Bode Plot block), you need to check on the 'Show plot on block open'.
댓글 수: 7
추가 답변 (1개)
Tianyu
2023년 9월 6일
Hi Kim,
Not sure if this is the best way but you can use "Control System Designer" under Simulink app tab.
Click "New plot" and select "New Bode". Then "Add Signal" > "Select signal from model".
Select the input/output signal in your model and plot.
For more information, check Design single-input, single-output (SISO) controllers - MATLAB (mathworks.com)
참고 항목
카테고리
Help Center 및 File Exchange에서 Get Started with Control System Toolbox에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!