Pulse-Doppler Radar Using Xilinx RFSoC Device: Load/deploy problem

I am trying to repeat the Matlab example of "Pulse-Doppler Radar Using Xilinx RFSoC Device". Eveything looks fine including connection (see photo) until load the bitstream (see photo). It seems Thir party tools required. I have installed all tools I can find, but the problem is still there. Could Matlab list clearly which tools required for this?

Thank you so much!

Answer 1

[James]

Make sure you've installed the correct Support Package.

https://www.mathworks.com/matlabcentral/fileexchange/70616-soc-blockset-support-package-for-xilinx-devices

[Weixian Liu]

Actually the 1st problem of thrid party is not solved by install the support package, but by setup, some tools were installed although the setup is not for ZCU111.

I hope that Matlab can improve the part to make it clear to end user.

However, there is still poblems un-solved, anyone know the answer? I don't know how to trouble shoot!

Thanks.

Answer 2

[Weixian Liu]

It seems I can solve the inteface problem by setup, however, new problem appears now. (see photo attached) May I know how to solve the problem? Thanks.

[Weixian Liu]

There is no answer for my question!

Answer 3

[Weixian Liu]

It seems I can solve the inteface problem by setup, however, new problem appears now. (see photo attached) May I know how to solve the problem? Thanks.

[Weixian Liu]

Nobody answer me!