Is it possible to run the power_wind_dfig model with ZERO speed?
조회 수: 3 (최근 30일)
이전 댓글 표시
I want to run the power_wind_dfig model starting at zero speed. The problem is that when I try so, the speed goes to -0.2 pu and the results don't make sense. Even with increasing wind speed, I cannot make the machine speed positive.
댓글 수: 0
답변 (1개)
Christine Li
2022년 9월 28일
편집: Christine Li
2022년 9월 28일
Hi Sahand,
Can you share how did you configure the model to start from 0 speed?
For this shipping example, the initial condition is defined by a .mat file. And the model has defined a InitFcn callback to load the inital values, where the inital motor speed is defined 0.993pu. Everytime when you hit run, it will load this .mat file.
One way to change the inital motor speed is to define the xInitial in 'PreLoadFcn' callback, and modify the inital motor speed to 0 by run this in the commond before run the model:
>> xInitial.signals(44).values = 0;
Here is the simulation result of motor speed with 0 inital:
Hope this is helpful!
Best,
Christine
댓글 수: 2
Christine Li
2022년 9월 29일
Hi Liasi,
Can you elaborate more about "The problem is that when I try so, the speed goes to -0.2 pu and the results don't make sense. "? and would you be able to start from zero speed, if not, what error message did you get?
Thanks,
Christine
참고 항목
카테고리
Help Center 및 File Exchange에서 Electromechanical에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!