4-PAM simulation error
조회 수: 15 (최근 30일)
이전 댓글 표시
I am Trying to just simulate a PAM 4 signal and demodulate it i keep getting this error.
i am using a random interger generator block in my simulink model.
there is no output from the integer genertaor when i connect it to the 4PAM block. i would like to generate and display pam4 signal and even add noise to it. Can i understand what is the problem here.
i have attached the file to this.
댓글 수: 1
답변 (1개)
Jaswanth
2024년 1월 3일
Hi Siddharth,
The key to resolving the error you're encountering in your Simulink model lies in setting the size of the random integer generation correctly. For a PAM-4 (4-level Pulse Amplitude Modulation) system, the integers used to modulate the signal must range from 0 to 3, which corresponds to the four distinct amplitude levels (hence the term '4' in PAM-4).
The error message you're receiving, "Input must be an integer between 0 and M-1," indicates that the input to the M-PAM Modulator Baseband block is expected to be within a specific range. In the case of PAM-4 modulation, 'M' is 4, so the range of acceptable integers is 0 to M-1, which translates to 0 to 3.
Please refer following image for guidance.
Hope the above information is helpful in resolving your issue.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Modulation에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!