I'm trying to set up a battery system such that: Battery is discharged with current input 1 until it reaches the minimum voltage Once Vmin is reached, it switches to input 2 & start charging the battery until it reaches the maximum voltage Once Vmax is reached, it swiches to input 1 & start discharging the battery I want this cycle to repeat until after a certain number of cycles. I was able to set the input so they run cyclicly during the simulation, but couldn't figure out how to set up the switching. I think it may use some edge detection or enabled subsystems but couldn't think of a way to make it work. Would really appreciate it if someone could give me a hint.

How to implement this logic in Simulink?

Wenlin

2022 4월 12

1 답변

조회 수: 4 (30일)

0 개 추천

I'm trying to set up a battery system such that:

Battery is discharged with current input 1 until it reaches the minimum voltage
Once Vmin is reached, it switches to input 2 & start charging the battery until it reaches the maximum voltage
Once Vmax is reached, it swiches to input 1 & start discharging the battery

I want this cycle to repeat until after a certain number of cycles.

I was able to set the input so they run cyclicly during the simulation, but couldn't figure out how to set up the switching. I think it may use some edge detection or enabled subsystems but couldn't think of a way to make it work. Would really appreciate it if someone could give me a hint.