필터 지우기
필터 지우기

2021a Error executing command "mw_setboot" command not found

조회 수: 13 (최근 30일)
ao sun
ao sun 2022년 2월 18일
편집: ao sun 2022년 2월 18일
Hi, I am currently using hdl workflow advisor to complete one job that is based on snickerdoodle black, a zynq 7020 device.
However as I completed most of the steps in hdlcode advisor, in the last step "programming target device" is failed and sadly I dont know how I can solve this.
Error executing command "mw_setboot '/tmp/hdlcoder_rd/hdlcoder_system.bit' '/tmp/hdlcoder_rd/devicetree.dtb' '/tmp/hdlcoder_rd' 'Demo System'". Details:
STDERR: bash: mw_setboot: command not found
As some solutions suggest in the community, it's a matter of one Mathwork Linux image, so I tried:
  1. To check if I have downloaded the zynq support packages, and I found I surely missed one, which is (Vision HDL Toolbox Support Package for Xilinx Zynq-Based Hardware) after I completed the setup process, this problem still remained.
Since I am using a board that is unlike Zedboard, it's not in the dropdown menu of (Vision HDL Toolbox Support Package for Xilinx Zynq-Based Hardware) so I am wondering if this is where the error was made. If it is, I think there is probably still a solution since as far as I know, Zybo also made through all the steps in hdl workflow advisor.
And I still have a question about the example of ledblinking project, as I showed below, my led output is actually not in the AXILite interface, it connects to a ground, it should not suppose to happen since I was following all the resources I can find online and it seems no one ever had mentioned this, so I dont know if this also can be one element that is affecting the outcome, but as I took a glance in vivado, the whole project seems fine, well at least for the PL part.
Anyway, thanks for reading my message.

답변 (0개)

제품


릴리스

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by