How can I use multimeter in the sequential circuit design with Xor gate and measure power in microwatts?
조회 수: 2 (최근 30일)
이전 댓글 표시
I am designing a sequential circuit using XOR gate in matlab2014 but when I ran the following errors occurs:
1. Invalid setting for input port dimensions of 'AHpower/Demux'. The dimensions are being set to [-1]. This is not valid because the total number of input and output elements are not the same. Component: Simulink | Category: Block error
2. Error in port widths or dimensions. Invalid dimension has been specified for output port 1 of 'AHpower/Multimeter'. Component: Simulink | Category: Block error How can I solve these errors?
댓글 수: 1
Joel Van Sickel
2023년 10월 13일
can you share your model? It probably has to do with how the multi-meter is set up and I can't tell just from the screenshot.
답변 (0개)
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Simscape Electrical에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!