currently i working on plotting a graph of rpm sensor on matlab but unfortunately when i run the plotting coding in Matlab it was failed.It said 'Warning: Unsuccessful read: Matching failure in format.' please help me,i dont know what is the problem
조회 수: 2 (최근 30일)
이전 댓글 표시
volatile int rpmcount = 0;
int rpm = 0;
unsigned long lastmillis = 0;
void setup(){
Serial.begin(9600);
attachInterrupt(0, rpm_car, FALLING);//interrupt cero (0) is on pin two(2).
}
void loop(){
if (millis() - lastmillis == 1000){ //Uptade every one second, this will be equal to reading frecuency (Hz).
detachInterrupt(0); //Disable interrupt when calculating
rpm = rpmcount * 60; // Convert frecuency to RPM, note: this works for one interruption per full rotation. For two interrups per full rotation use rpmcount * 30.
Serial.print("RPM =\t"); //print the word "RPM" and tab.
Serial.print(rpm); // print the rpm value.
Serial.print("\t Hz=\t"); //print the word "Hz".
Serial.println(rpmcount); //print revolutions per second or Hz. And print new line or enter.
rpmcount = 0; // Restart the RPM counter
lastmillis = millis(); // Uptade lasmillis
attachInterrupt(0, rpm_car, FALLING); //enable interrupt
}
}
void rpm_car(){ // this code will be executed every time the interrupt 0 (pin2) gets low.
rpmcount++;
}
댓글 수: 0
답변 (2개)
Image Analyst
2014년 11월 11일
This is C or Java code, not MATLAB code. Use MATLAB instead.
댓글 수: 4
Walter Roberson
2018년 6월 3일
You have the Arduino sending "RPM =" and "Hz=" but your MATLAB code is expecting only numeric values.
Osama Yassin
2018년 6월 3일
Hi, Nazrin Zaini .. did get the solution about attachInterrupt function in matlab?
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 MATLAB Support Package for Arduino Hardware에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!