Open wound/winding induction motor model in Simulink/Simscape

Is there a open wound induction motor model available in Matlab simulink?

The requirement is similar as shown in the figure below.

Thank you.

Answer 1

[Joel Van Sickel]

The simscape motors have both ends of the stator exposed. This is mainly so you can decide if they are wye or delta connected, but they would allow for this type of setup as well. This exaple shows how the stator can change between wye and delta. However, this example uses a squirrel cage, so I have included a link to all of the motors which includes a wound rotor as well.

exposed stator windings example:

https://www.mathworks.com/help/physmod/sps/ug/three-phase-asynchronous-machine-starting.html

list of asynchronous machines including wound rotor:

https://www.mathworks.com/help/physmod/sps/asynchronous.html?s_tid=CRUX_lftnav

Regards,

Joel