How could I get measurement output from block Synchronous Machine (Six-Phase) to design controllers?
조회 수: 1 (최근 30일)
이전 댓글 표시
How could I get measurement output from block Synchronous Machine (Six-Phase) to design controllers?
In the block, there is no port to get measurement of the machine (torque, velocity...)
댓글 수: 0
채택된 답변
Joel Van Sickel
2021년 11월 15일
편집: Joel Van Sickel
2021년 11월 15일
Hello,
unfortunately since this block lacks a measurement port, you have to attatch the appropriate sensors externally to measure all of these values. You can put a torque sensor on the mechanical shaft of the motor to capture that value and current sensors on the output phases. Similarly, you can put a position/speed sensor on the output shaft to get the speed and position.
This example is useful: https://www.mathworks.com/help/physmod/sps/ug/six-phase-pmsm-torque-control.html
Regards,
Joel
댓글 수: 0
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Magnetic Elements에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!