Mex -setup compiler
조회 수: 6 (최근 30일)
이전 댓글 표시
My MATLAB Version is 7.11.0.584 (R2010b) and i am trying to run a simulink model on it.
But an error occur during the parsing phase: "Unable to locate 'mexopts.bat', and therefore cannot determine which compiler to use for simulation builds. Use 'mex -setup' to select a supported compiler."
So i t typed mex -setup in the MATLAB command prompt and it appears that there are no compiler available. So how do i get the compiler to allow my simulink model to run successfully?
Thanks
댓글 수: 2
nikhilsinghgangwar
2017년 2월 14일
what after i have downloaded the compiler. its saying somnething about the location.Though i have already installed it
Walter Roberson
2017년 2월 14일
nikhilsinghgangwar, which MATLAB version are you using, and exactly which compiler have you installed? Did you install VS Professional, VS Ultimate, VS Community, VS Express ?
채택된 답변
Bruno Luong
2011년 2월 14일
I guess you run Matlab on 64-bit platform (The factory LCC is the only available for 32). A free compiler is Microsoft Visual Studio Express. You need to download and install it.
댓글 수: 0
추가 답변 (1개)
Andreas Goser
2011년 2월 14일
I also would guess this is that you need to install a C compiler. Here is the full list:
I heard people struggling with not correctly applying the right SDK for the MSVC Express editions, so my advice is to look at this very carefully.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Introduction to Installation and Licensing에 대해 자세히 알아보기
제품
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!