Pause a process, using a NI USB6008
조회 수: 2 (최근 30일)
이전 댓글 표시
Hello, I have the following problem:
I have two sensors connected to a NI-USB6008 data acquisition device, and one analog output which turns on a flashlight.
The thing is that I need this flashlight to turn on a few seconds after the data is being received, and turn of a few seconds before the process ends.
I know that this device does not support clocked processes, because it has no timer inside, but is there a way that, by using pause or some similar command, I can control when the flashlight turns on and off?
Thanks in advance!
P.S.: I attached the script I'm using. Don't worry about the comments in spanish :)
댓글 수: 0
답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 National Instruments Frame Grabbers에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!