Rotation sequence SimMechanics 2nd Generation

조회 수: 1(최근 30일)
Etienne Coetzee
Etienne Coetzee 2014년 3월 26일
답변: Steve Miller 2021년 11월 17일
Hi All
I am trying to build an aircraft model in SimMechanics and am using the HL-20 with Landing Gear as an example. Unfortunately I cannot figure out how to use the SimMechanics 2nd generation to implement this model. I am stuck at the the very first step of building an equivalent aircraft model, where one compares the output for the SimMechanics model and a point model from the Aerospace Blockset to check that the rotation sequences are correct. It used to be simple to define the rotation sequence i.e. Z-Y-X, but I cannot see hot to do this now. The original implmentation is at the top of the picture and my attempt in the new version below.
The rotations are needed to define the z-axis for the joint, but the results are just not the same. Any help would be appreciated.

답변(1개)

Steve Miller
Steve Miller 2021년 11월 17일
The sequence of blocks and transforms looks correct to me. It is hard to tell without the settings from the models. It is possible you haven't put the initial conditions in properly, as that is different between first and second generation. You need to enter them in the Joint blocks under Joint Targets.
--Steve

범주

Find more on Unit Conversions in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by