필터 지우기
필터 지우기

How to fill blood vessel pixels

조회 수: 2 (최근 30일)
Arslan Ahmad
Arslan Ahmad 2013년 11월 24일
답변: Image Analyst 2013년 11월 24일
I want to fill the blood vessel pixel with 1's and at the same time I want to remove the noisy little spots from the image. This image is obtained after the application of canny edge detector to source image. I will be grateful for your help.

이 질문에 답변하려면 로그인하십시오.

채택된 답변

Image Analyst
Image Analyst 2013년 11월 24일
Maybe Canny is not the way to go. Is that one of the methods listed in section 20.5 here: VisionBib ophthalmology articles, or are there better methods listed? Don't waste time on a method known to be not very good. Find a published one that works, and then improve it if you want. If you're doing this for graduate research, you can't publish a paper on some old elementary algorithm. You either have to invent a new one or improve on an existing one.

추가 답변 (0개)

카테고리

Help Center 및 File Exchange에서 Biomedical Imaging에 대해 자세히 알아보기

태그

제품

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by