Setting input ranges using the Trim function

조회 수: 10 (최근 30일)
Mungo
Mungo 2011년 6월 29일
답변: Francesco 2014년 7월 9일
Hi,
I have a Simulink model with two inputs and four outputs. I was wanting to use the Trim function to linearise the model about a certain output point, but the inputs of my system have specific ranges that they cannot go outside of. Is there any way to set the inputs to not go outside the range of -1 to 1 when using the Trim function.
Many thanks Mungo

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Francesco
Francesco 2014년 7월 9일
Hi,
I would also be interested in an answer to this question...

카테고리

Help Center 및 File Exchange에서 Modeling에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by