I2C 장치
R2026bI2C 함수를 사용하기 전에 arduino를 사용하여 Arduino 객체를 만듭니다. 자세한 내용은 Connect to Arduino Hardware 항목을 참조하십시오. MATLAB® 및 MATLAB Online™에서 Arduino 탐색기를 사용하여 I2C 통신 인터페이스를 대화형 방식으로 구성하고, 이 인터페이스를 사용해서 Arduino 및 기타 지원되는 하드웨어에 연결된 I2C 장치의 데이터를 읽고 쓸 수 있습니다. 자세한 내용은 Connect to I2C Device Using Arduino Explorer App 항목을 참조하십시오.
설치된 MATLAB 버전에서 지원되는 하드웨어의 전체 목록을 보려면 Supported Hardware 항목을 참조하십시오. MATLAB Online에서 지원되는 보드, 워크플로, 플랫폼에 관한 자세한 내용은 Get Started with MATLAB Online for Arduino 항목을 참조하십시오.
참고
scanI2CBus 함수를 제외한 모든 함수는 MATLAB Function 블록을 사용하여 코드를 생성합니다. 자세한 내용은 Deploy Arduino Functions to Arduino Hardware Using MATLAB Function Block 항목을 참조하십시오.
함수
device | Connection to device on I2C bus on Arduino or ESP32 hardware |
scanI2CBus | Scan I2C bus on Arduino hardware for device address |
read | Read data from I2C bus |
write | Write data to I2C bus |
readRegister | Read data from I2C device register |
writeRegister | Write data to I2C device registers |
도움말 항목
- Communicate with an I2C EEPROM Device
Learn how to store and retrieve data from an I2C EEPROM device.
- Measure Temperature from I2C Device on Arduino Hardware
Learn how to measure temperature from an I2C device on your Arduino hardware.
- Arduino I2C Interface
Learn how Arduino hardware interfaces with the I2C protocol.
- Use Arduino Explorer App
Learn how to use the Arduino Explorer app to configure GPIO pins and communication protocol interfaces and visualize data.
- Connect to I2C Device Using Arduino Explorer App
I2C (Inter-Integrated Circuit) is a two-wire serial communication protocol that uses a serial data line (SDA) and a serial clock line (SCL) to exchange data between a controller and one or more peripheral devices.