설치 및 설정

하드웨어 지원 패키지 설치 및 하드웨어 연결 설정

Communications Toolbox™ Support Package for Analog Devices^® ADALM-Pluto Radio를 사용하기 전에 다음을 수행해야 합니다.

Install Support Package for Analog Devices ADALM-PLUTO Radio의 지침에 따라 이 지원 패키지를 설치합니다.
호스트-무선통신 하드웨어 설정 안내에 나와 있는 단계에 따라 호스트 컴퓨터와 무선통신 간의 통신을 설정합니다.

함수

`configurePlutoRadio`	Configure ADALM-PLUTO radio firmware
`findPlutoRadio`	Report information about attached radios
`sdrdev`	Create radio object for specific radio hardware

comm.SDRDevPluto Create object for Analog Devices ADALM-PLUTO radio

Supported Hardware and Required Software
Get an overview of supported hardware and required software products.
Install Support Package for Analog Devices ADALM-PLUTO Radio
Install the Communications Toolbox Support Package for Analog Devices ADALM-Pluto Radio.
Guided Host-Radio Hardware Setup
Follow an automated hardware setup process to establish communication between the host and the radio hardware.
Manual Host-Radio Hardware Setup
Follow a manual hardware setup process to establish communication between the host and the radio hardware.
What to Do After Installation
After you have successfully installed the support package, you can do any of the following:
Setup for Two Radios Connecting to One Host
Set up two radio hardware devices connected to one host computer.
Uninstall Support Packages
Uninstall the support package using the Add-On Manager.

Resolve issues encountered while installing or using the features of the support package.