Community Profile

photo

tq yu


Last seen: 거의 2년 전 |  2019년부터 활동

Followers: 0   Following: 0

통계

  • First Answer
  • Revival Level 1
  • Thankful Level 1

배지 보기

Feeds

보기 기준

답변 있음
how can i send datas(rea-time ,get from udp communication) from the workspace to simulink while the simulation is on?
Has been solved ,thanks

거의 5년 전 | 0

| 수락됨

질문


how can i send datas(rea-time ,get from udp communication) from the workspace to simulink while the simulation is on?
hi ,everybody there I want to send sensors datas in the matlab workspace derieved from udp communication to simulink model ,to...

거의 5년 전 | 답변 수: 1 | 0

1

답변

답변 있음
How to use real time input from workspace in Simulink
hi ,there ,have you solved the problem?I just encounter the similar issue .Below is the similar QS by onther ,wish to help you. ...

거의 5년 전 | 0

답변 있음
why the sensing output of the joint block(vel,acce,torque) is all zeros? I set the motion in actuator : provided by input(from workspace) and the torque:automatilcally computed .The manipulata move as expected .
have a look at the similar situation: https://ww2.mathworks.cn/matlabcentral/answers/377250-why-is-measured-joint-velocity-zero...

거의 5년 전 | 0

| 수락됨

질문


why the sensing output of the joint block(vel,acce,torque) is all zeros? I set the motion in actuator : provided by input(from workspace) and the torque:automatilcally computed .The manipulata move as expected .
As above . The sensing position is presicely the same as input joints angles from workspace ,but the sensing vel,acce and the t...

거의 5년 전 | 답변 수: 1 | 0

1

답변

질문


after import robot from urdf ,how can i sent angles to the joints ,and test my own kinermatic algorithm?
I have a problem and need help. I want to use 'smimport' by simscape or 'importrobor' by robotics robotics system toolbox from ...

대략 5년 전 | 답변 수: 1 | 0

1

답변