필터 지우기
필터 지우기

out of memory error while reading binary file

조회 수: 18 (최근 30일)
Ricky
Ricky 2013년 8월 9일
댓글: Wave 2020년 4월 18일
Hello Everyone,
I am reading a binary file whose size is 644 MB. For reading the binary file I use the following command
[data,count] = fread(fileId, '*uint8');
When I start my MATLAB and type memory in the command window I get the following reponse.
Maximum possible array: 1150 MB (1.205e+09 bytes)
but when I read my binary file I get an out of memory error . I think it is because the fread function creates a column vector data whose size exceed the maximum possible array size.
Can someone help me how to read in a big binary file without facing the memory error. The contents of my binary file is reading from sensor being read through LAN port.

답변 (2개)

Jan
Jan 2013년 8월 9일
편집: Jan 2013년 8월 9일
It looks like FREAD allocates the memory in chunks with a growing buffer. This can exhaust 1 GB of free RAM easily for 640 MB of data. Try this:
Info = dir(FileName);
FID = fopen(FileName, 'r');
[data, count] = fread(fileId, [1, Info.bytes], '*uint8');
fclose(FID);
Then FREAD knows the size of the required input buffer.
But on the other hand it would be easy for FREAD to check the file size, when the dimensions are not specified. If the above method really works, send an enhancement request to TMW and ask for a proper pre-allocation in FREAD.
A general problem remains: You have only a very small amount of free RAM. Using a 64 bit version and installing further GBs is the best solution.
  댓글 수: 6
Jan
Jan 2013년 8월 12일
When you check the available memory and get 1150 MB, this might be different tomorrow or even in a few milliseconds due to other processes running on the computer. There is no trustworthy way to guarantee the availability of a block of memory but reserving it and check for success.
When your program run out of memory, installing more RAM under a 64 bit system is the only reliable way.
You can read the file in chunks even without memory mapping: Simply call FREAD for a certain block. This might even be faster than importing the complete file at once.
Wave
Wave 2020년 4월 18일
Hey Jan,
the problem is still there (Matlab 2019b) with the pre-allocation problem.
Thank you for your solution. It works quiete good with fread(fileId, [1, Info.bytes], '*uint8');

댓글을 달려면 로그인하십시오.


Rodney Thomson
Rodney Thomson 2013년 8월 9일
Change your format specifier to 'uint8=>uint8'
This says: "my data is uint8 AND I want to store it in a uint8 array"
Otherwise MATLAB jus tassumes it should read a uint8 value and put it in a double. Which is 8 times the size, or 4.8GB in the case of your array!
  댓글 수: 3
Jan
Jan 2013년 8월 9일
*uint8 is equivalent to uint8=>uint8.
Rodney Thomson
Rodney Thomson 2013년 8월 10일
Sorry, I didn't notice the *!

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Performance and Memory에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by