GPU Computing
조회 수: 7 (최근 30일)
이전 댓글 표시
I just tried running the following code:
N = 6;
M = magic(N);
G = gpuArray(M);
??? Error using ==> gpuArray at 28
An error occurred during: setting up the CUDA device. The CUDA error was: (Unknown code: 10100).
And I got the above error and am not sure why.
I'm running Mac OSX 10.6.6 on a Macbook Pro, Matlab 2010_b, an NVIDIA gpu ( Chipset Model: NVIDIA GeForce GT 330M Type: GPU Bus: PCIe PCIe Lane Width: x16 VRAM (Total): 512 MB )
and I just downloaded CUDA Driver Version: 3.2.17 and installed it.
Any suggestions?
댓글 수: 0
채택된 답변
Edric Ellis
2011년 2월 3일
Unfortunately, that GPU is compute capability 1.2, and Parallel Computing Toolbox requires GPUs with compute capability 1.3 and above. (I'm not sure quite why you're getting such a cryptic error message though). There's a post over on the newsgroup explaining why 1.3 is required:
댓글 수: 0
추가 답변 (4개)
Jeremy
2011년 2월 4일
댓글 수: 5
Walter Roberson
2011년 2월 20일
Thanks, Mark. I see that the Quadro 4800 is also available in the Apple store. Neither are configurable in the configure-your-own system (at least not for Canada), so it appears you have to buy the ATI and then add the NVIDIA as a separate purchase.
The ads and press releases from other years show the Quadro 4500 and 5400 as previously having been available for the G5 and Mac Pro as build-to-order options.
Mark Shore
2011년 2월 21일
I just noticed Jeremy had a question there. You can find the compute capabilities of different GPUs here:
http://www.nvidia.com/object/cuda_gpus.html
Denis Zhegalin
2011년 2월 17일
Hello, I've got the same error.
??? Error using ==> feval An error occurred during: setting up the CUDA device. The CUDA error was: (Unknown code: 10100)
I have two teslas c2050 + quadro for OS purposes. What to test ?
One remark, I use remote desktop access.
Najeeb Ahmad
2011년 3월 3일
I have TESLA C1060 (as compute only non-graphic device) and getting same error in MATLAB. What should I do???
Note: Using TELSA 263.06 WHQL driver (has TCC capability but I didn't find nvidia-smi.exe to exclusively switch it into TCC mode).
댓글 수: 1
Jason Ross
2011년 3월 3일
Try the 263 developer drivers from
http://developer.nvidia.com/object/cuda_3_2_downloads.html
This is what we downloaded and it's definitely there.
Najeeb Ahmad
2011년 3월 8일
Thanks for your reply!
I finally found that Tesla TCC driver doesn't work with Windows 7 32-bit. Now I have installed Windows 7 64-bit and Tesla C1060 TCC driver. It is working without a problem.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Get Started with GPU Coder에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!