Low-cost video capture devices compatible with Image Acquisition Toolbox?
조회 수: 2 (최근 30일)
이전 댓글 표시
Hello,
I need to capture an analog video signal (via either coax, vga, or rca) using the image acquisition toolbox, and I'd like to do it without buying an expensive frame grabber if possible. I have seen the brands listed here for compatibility:
but it doesn't specify brands for simple video capture devices. Might anyone have some advice or suggestions?
Thanks.
댓글 수: 2
Paul Sponagle
2016년 11월 17일
I have a similar problem. I want to be to take an RCA video input (NTSC) from any camera and manipulate in MATLAB. I have an Elgato USB video capture device, but it doesn't look like MATLAB supports it. Elgato support were not helpful as they said their device must use their software.
Mac solution is preferred, but PC will work too.
XING HU
2017년 3월 10일
Hi, my frame grabber is V.TOP External USB Video/Audio Capture Card. how do you solve your problem finally? thanks
답변 (2개)
Image Analyst
2013년 4월 24일
I use a simple Logitech webcam with ease. It's inexpensive.
댓글 수: 4
Image Analyst
2013년 4월 25일
By "image capture device" you mean a frame grabber board, not a camera? So you already have some particular camera that you must use? And it's not a supported one that uses a standard interface like firewire or USB? And you need to use one of the supported frame grabber boards to grab frames from that camera? If so, have you contacted the supported frame grabber board manufacturers to see if they can capture your device's signal?
Walter Roberson
2013년 4월 24일
Is the input source NTSC or PAL, or something else?
댓글 수: 2
Walter Roberson
2013년 4월 24일
I got side-tracked looking for something affordable, as the prices I was finding for the known supported devices are around $US1900 - $US2300.
참고 항목
카테고리
Help Center 및 File Exchange에서 National Instruments Frame Grabbers에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!