supress high amplitude signal and only keep low amplitude
조회 수: 2 (최근 30일)
이전 댓글 표시
i have a continuous positive signal which has a wave of high amplitude followed by a low aplitude i want to supress the high amplitude wave completely and only keep low amplitude signal
댓글 수: 5
Youssef Khmou
2013년 3월 5일
편집: Youssef Khmou
2013년 3월 5일
hi,@Wayne and @Juan : the Amplitudes are Completely added only if the signals have the same Frequency and same phase .
I reproduce Wayne s example ( modified ) :
t = 0:0.001:1-0.001;
x = 2*cos(2*pi*100*t);
y = 4*cos(2*pi*100*t-pi/8);
z = x+y;
plot(t,z)
x and y have the same Freq, but y contains a delay phase (pi/8) then Max(Z)=5.69 not 6 v .
Juan Camilo Medina
2013년 3월 5일
편집: Juan Camilo Medina
2013년 3월 5일
OK, if the phases are different, the result is not exactly the same wave with amplitude equal to the sum of the other two waves. But still, the result is a "single" wave with the same frequency but shifted and different amplitude. If that is what you have, try a Fourier type sine-cosine basis functions decomposition:
t = 0:0.001:1-0.001;
a=5; phi=-1/8; f=10;
x = a*sin(2*pi*f*t+phi); % origial"mixed" wave
figure(1); clf; plot(t,x); hold on;
% decomposition into fourier basis functions
y = (a*sin(pi/2+phi))*sin(2*pi*f*t);
z = (a*sin(phi))*cos(2*pi*f*t);
plot(t,y+z,'--r')
채택된 답변
Juan Camilo Medina
2013년 3월 5일
If they oscillate at different frequencies, you can create a high-pass filter, just read the help for the functions
[B,A] = butter(N,Wn,'high'); % this is just one of many filters types
Y = filter(B,A,X); % where X is your signal
댓글 수: 0
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Signal Analysis에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!