Power gui problem help
조회 수: 1 (최근 30일)
이전 댓글 표시
How to run 2 power gui in a signal matlab file? I want to run 1 powergui with continuous signal and 1 power gui with phasor signal. What should I do plZ help
댓글 수: 0
채택된 답변
Joel Van Sickel
2020년 3월 6일
이동: Sabin
2023년 1월 4일
Hello Mitesh,
you can create a model reference and put one of your powergui blocks and the associated electrical network inside the model reference, and it will use the local model reference settings. This approach will require manually cleaning up the generated model reference and probably manually setting some of the output ports to work with complex signals (if you are using phasor).
You only need to put one of them in a model reference. It will be easier if you put the continuous time system in the model reference and leave the phasor system at the top level.
Regards,
Joel
댓글 수: 0
추가 답변 (0개)
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Switches and Breakers에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!