Enforcing grouping in the Symbolic Math toolbox

조회 수: 2(최근 30일)
Arwel 2020년 2월 25일
답변: Walter Roberson 2020년 2월 28일
I have a question regarding controlling the grouping of terms in the symbolic math toolbox. I've tried to figure out how to put the question directly into this window, but couldn't figure it out. So, in the end I've exported the relevant live worksheet as a PDF and attached it to this question...
But essentially, I want to control how Matlab groups terms. In the attached, I want to stop matlab splitting up f_siw1 when I substitute it into Dsi_w1 (it doesn't make sense for later in the calculation to split them).
How can I do this, or control the grouping of terms generally? Is there a syntax that will let me do this?
  댓글 수: 1
Devineni Aslesha
Devineni Aslesha 2020년 2월 28일
In the attached PDF, the desired expression and the answer obtained using ‘subs’ function in MATLAB are same. Also, could you provide information on how it doesn't make sense later on in the calculation to split them?

댓글을 달려면 로그인하십시오.


Walter Roberson
Walter Roberson 2020년 2월 28일
You need to use either evalin(symengine) or feval(symengine) to issue commands directly to the symbolic engine, and you would have to issue hold() calls at appropriate places.
This is a difficult construct to use well, and your symbolic engine might reset if you try to display the expression.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by