How to model tapped windings in Simscape?
조회 수: 7 (최근 30일)
이전 댓글 표시
Hello,
I want to model a multi output flyback transformer with tapped at secondary windings. Therefore there will be two output of the transformer according to number of turns above and below the tap.
So far I have used a model as attached and also I a attached the configuration i want in reality.
I would like to know do the model and the reality match each other?
Any help will be highly appreciated.
Thanks
댓글 수: 0
답변 (2개)
Nikhil Sonavane
2020년 1월 30일
You can refer to the documentation of Multi-Winding Transformer block which gives a detailed explanation about tapped transformer windings. You can adjust the number of of this block by double clicking on it adjusting the number of taps as required. You can also refer to the screenshot which I have attached.
댓글 수: 3
Adithya C
2023년 2월 15일
You can use Mutual Inductor block in the MATLAB physical model system.
댓글 수: 0
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Foundation and Custom Domains에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!