lookup table in simulink
조회 수: 15 (최근 30일)
이전 댓글 표시
Hi All ,
I am new to simulink . I am trying to create a look up table with certain correction factor values . Problem that I face is that my breakpoints are not evenly spaced so when I use simulink 1D lookup table block , I get error . Any work around for this problem .
Thanks in advance
댓글 수: 0
채택된 답변
Jim Riggs
2019년 9월 23일
There is no reason that non-uniform breakpoint spacing should be causing an error with the 1D interpolation function. I think that the error is from some other cause. You need to provide more information.
How are you defining the interpolation table (can you show the values)
What exact error message is being given?
댓글 수: 2
Jim Riggs
2019년 9월 23일
편집: Jim Riggs
2019년 9월 23일
OK. It's not the breakpoint spacing, but that the values are decreasing.
You can simply flip the table so that the breakpoints are increasing.
Also, the requirement for monotonicity applies ONLY to the breakpoints. The data values associated with them can be anything.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Nonlinearity에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!