Error: Unable to locate 'mexopts.bat'
조회 수: 6 (최근 30일)
이전 댓글 표시
I am trying to simulate the file in the following link-
But i am getting a error message "Unable to locate 'mexopts.bat', and therefore cannot determine which compiler to use for simulation builds. Use 'mex -setup' to select a supported compiler." Please somebody suggest some solution of it.
댓글 수: 0
채택된 답변
Matt Fig
2012년 9월 11일
I would suggest you follow the advice of the error message! Type this at the command line:
mex -setup
댓글 수: 4
mohamed fathalla
2013년 5월 13일
편집: mohamed fathalla
2013년 5월 13일
hi all
i use (mex -setup)
- the output is :
Select a compiler:
[0] None
Compiler:
i enter number 1
the output is
Please select from 0-0
Compiler:
i enter 0 the output is
mex: No compiler selected. No action taken.
i need help
Kaustubha Govind
2013년 5월 13일
You need to install a supported compiler if you don't have one already. Look at the last column on this page against your MATLAB version: http://www.mathworks.com/support/sysreq/previous_releases.html
추가 답변 (2개)
Jesse Lee
2020년 9월 13일
I got the same question,"Unable to locate 'mexopts.bat', and therefore cannot determine which compiler to use for simulation builds.
And I try to enter 'mex -setup' the output is :
Unknown encoding 'cp65001' at D:\Program Files\MATLAB\R2010b\bin\/mexutils.pm line 154
??? Error using ==> mex at 208
Unable to complete successfully.
PS: my version is 2010b. And actually, I've already installed the compiler, which I can see on 2020a
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Solar Power에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!