simulation of stepper motor with microstepping
조회 수: 6 (최근 30일)
이전 댓글 표시
Hey all, I've been trying to simulate a hybrid stepper motor by using microstepping. Therefore, i took the power_steppermotor demo that comes with matlab/simulink and intended to feed it with a signal similiar to the one explained on page 8, http://www.deltron.ch/pdf/produkte/motoren/Schrittmotor_kurz_erklaert_d.pdf However, given the stepper motor demo, I get an unstable system reply just by decreasing the required step angle in the motor parameter dialog box to less than 0,45°. Is there any example for a stepper motor in micro step control? I'm looking for a couple of hours so far but I'm unable to find anything appropriate... Hope you can help me out somehow.
br
Kev
댓글 수: 2
답변 (1개)
Sabin
2023년 1월 7일
A good starting point is the Stepper Motor Averaged Mode example in Simscape Electrical. In this example there are three stepping methods: Full stepping, Half stepping, and Microstepping.
댓글 수: 0
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Electromechanical에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!